1. During the feeding operation, there should be a special person to cooperate with the forklift truck driver, so that the steel coil material is basically consistent with the center of the expanding and contracting drum shaft, and then the forklift truck driver slowly puts the steel coil material on the trolley.
2, the operator to rise or fall (hydraulic jack), the steel coil material to adjust the expansion and contraction drum shaft center (that is, the material can go into the expansion and contraction shaft), at this time adjust the top of the uncoiler movable bearing seat, so that it and the uncoiler keep in the same level line.
3. Adjust the expansion nut to make the four arch plates and tighten the coil material to avoid the deformation and damage of the coil material.
4. After the steel coil material is expanded, turn the uncoiler by hand to observe whether the material can rotate freely to avoid various hidden dangers in the work.
Osoba kontaktowa: Mr. Arno Hao
Tel: +8618717894416
